Calculators

Numbers you can take to the machine.

Four calculators our own machinists and inspectors use. Every result shows the formula, so you can check the math, print the card and put it in the traveler.

Tap drill finder.

Pick the thread. Get the drill.

Cutting, form or helical insert. Set the thread percentage and the finder picks the nearest standard drill and tells you what you actually get.

Tap drill finderRev. Nov 2026
Units
Tap style
50%drill = major minus K x percent x pitch85%
#7Tap drill

0% threadbar: what you get, line: what you asked for100%

Bend calculator.

Flat pattern from the bent part.

Bend allowance, bend deduction, setback and flat length for one bend, with the minimum radius and minimum flange checks for your material.

Sheet metal bend calculatorAir bending
Units
How to measureFlange lengths are outside dimensions to the apex (where the outside faces would meet). Bend angle is the angle the part is bent through: 90 for a right angle bend.
3.896Flat length in

BA = (π / 180) × angle × (R + K × T)  ·  OSSB = tan(angle / 2) × (R + T)  ·  BD = 2 × OSSB − BA  ·  Flat = A + B − BD
Air bend radius ≈ 0.16 × V die opening, V ≈ 8 × T  ·  Minimum flange ≈ V / 2 + R + T

True position.

Is the hole where the print says?

Deviation to true position, bonus tolerance at MMC or LMC, pass or fail, and a picture of the zone.

True position calculatorASME Y14.5
Units
Feature
Material condition
.0100True position Ø in

Within tolerance
TP = 2 × √(ΔX² + ΔY² [+ ΔZ²])  ·  Bonus at Ⓜ: hole = actual − MMC, pin = MMC − actual  ·  Bonus at Ⓛ: hole = LMC − actual, pin = actual − LMC  ·  Allowed = stated tolerance + bonus

Gage ball.

Check a countersink with a ball.

Measure the ball height, get the countersink diameter. Or start from the target diameter and know what height to expect.

Gage ball countersink calculatorInspection
Units
I know
Countersink angle 82°
How to measureDrop the ball in the countersink. Measure from the part surface to the top of the ball with a height gage or depth micrometer. A negative height means the ball top sits below the surface.
.3850Countersink Ø in

Ball rides on the cone
α = angle / 2  ·  r = ball Ø / 2  ·  D = 2 × tan α × ( r × (1 + 1 / sin α) − H )  ·  H = r × (1 + 1 / sin α) − (D / 2) / tan α
Contact circle Ø = ball Ø × cos α. It must be larger than the hole and smaller than the countersink Ø, or the ball is not touching the cone.